AEM TRU BOOST CONTROLLER - Electronic boost controller

The Tru-BoostX boost controller delivers all the features you loved about the original. They have thrown AEMnet into data logging and a large, bold internal MAP sensor that can handle boost pressures up to 80 PSI.

The Tru-boostX Boost Controller gauge delivers digital accuracy but with the simplicity of a manual boost controller. All programming is done using the front-plate buttons, and therefore no laptop is required for this.

Program two boost levels + Scramble boost setting:
Program 2 boost modes for various performance levels (up to 80 PSIg), and program a time-based scramble boost setting controlled by a switched input. You can also turn off the controller and use the meter as a display.

Wastegate Open Pressure:
Ideal for reducing boost spikes and improving wind turbine for example.

Boost levels in PSIg (PSI), bar, or kPa (PAS):
See your boost in the device you prefer and scale the 24 exterior LEDs to match your maximum boost levels for the perfect run.

Set alarms and show Peak boost
Set the 24 green outer LEDs to blink based on boost pressure so you are warned of an overboost. A ground output is included to trigger an optional LED warning light. Select the "B" button to see the top boost level and clear the value using the menu.

Built-in overboost protection:
Protects your engine from an overboost condition by closing the boost control magnet until it is reactivated by you through the buttons on the front panel.

Integrated fault protection:
Warns you of errors if the boost control solenoid valve is shorted or disconnected so you never doubt Tru-BoostX is operating.

Directory using AEMnet CANBUS:
Output channels via AEMnet provide so much more than just increased boost. Send 13 channel data via a 2 wire connection, including boost pressure, peak boost, boost target, boost scramble duty, overboost status, wastegate crack pressure, boost control solenoid valve and more.